Skip to main content

Mon–Fri 8:00 AM – 5:00 PM

Call (408) 942-5488
Bay City AutomotiveMilpitas · Since 1996
A close up of a brake on a vehicle

Ready to book · Brakes and safety

Do you really need new rotors with new brake pads?

Short answer: Not always. Rotors need replacement when they are below the minimum thickness stamped on them, warped enough to cause pulsation or deeply scored. If they measure within specification and the surface is good, new pads can go on the existing rotors.

By the Bay City Automotive team · Reviewed by shop technicians · Last updated

A close up of a brake on a vehicle
Image description: A close up of a brake on a vehicle. Photo via Unsplash.

How we decide

We measure rotor thickness with a micrometer and check runout, which is the side-to-side wobble that causes pulsation. We show you both numbers next to the manufacturer's minimum.

Why many shops replace them anyway

Modern rotors are thinner than older designs and often leave little room for resurfacing, so replacement is common. It should still be a measured decision and not an automatic line on the quote.

What good rotors allow

When rotors pass, a pad replacement with cleaned and lubricated hardware gives quiet, even braking for a lower total cost.

How Bay City Automotive handles this

Bay City Automotive repairs brakes in Milpitas, from pads and rotors to calipers and fluid. We measure pad thickness and rotor condition, show you the readings and quote only what the measurements support.

Learn more on our brake repair page, or call (408) 942-5488 and a technician will explain your options before any work begins.

Key takeaways

  • How we decide.
  • Why many shops replace them anyway.
  • What good rotors allow.

Frequently asked questions

Can rotors be resurfaced instead?

Sometimes, if there is enough thickness remaining after machining. We will tell you if yours qualify.

Book this service

Tell us what your car is doing and we will take a look. Same-day appointments are often available.